How to Install NTP on Almalinux 9

Network Time Protocol (NTP) is a protocol that permits you to synchronize the time of your computer with an internet-based trusted time server. This is significant to make sure every device in your network gets accurate synchronizations. This guide will take you step by step through the process of install NTP on AlmaLinux 9.

Step 1. Update almalinux server

Before install NTP, it is good to make sure that your system is updated. Open terminal on your almalinux and run the following command:

sudo dnf update

Step 2. Install NTP package

Now, let’s move to the next step that is setup NTP package on your almalinux. This involves run the following command in the terminal:

sudo dnf install ntp

Step 3. Enable and start the NTP service

When you have installed the NTP package, you will have to enable and start the NTP service. typing these commands:

sudo systemctl enable ntpd

sudo systemctl start ntpd

Step 4. Setting up NTP servers

By default, ‘/etc/ntp.conf’ file contains the servers NTP service will use. If you need to add more NTP servers, then make changes to this file. Open it with a text editor:

sudo nano /etc/ntp.conf

Scroll down to the server directives and put in the IP addresses or domain names of NTP servers that you want to use. Save then exit from the file.

Step 5. Confirming the status of NTP service

To establish that the condition of your service concerning NTP is alright, you may want to check it using this command

sudo systemctl status ntpd

If the service is running normally, it implies that you have managed to install and configure NTP on AlmaLinux 9 properly.

Summary

This tutorial has demonstrated how to get NTP installed in AlmaLinux 9, and have it adjusted to align your system’s time with trustworthy NTP servers. This process will help all the gadgets connected to your network operate in harmony when it comes to time synchronization and prevent misconfiguration regarding time.